Не работает j-link c CooCox

[inkHunter]

Как настроить j-link c CooCox ??!!! Вот так настроил но ничего (

Вот что получаю




Через SEGGER -> J-Flash ARM подключаеться:
Connecting ...
- Connecting via USB to J-Link device 0
- J-Link firmware: V1.20 (J-Link ARM V8 compiled Feb 8 2012 14:30:39)
- JTAG speed: 5 kHz (Fixed)
- Initializing CPU core (Init sequence) ...
- Initialized successfully
- JTAG speed: 4000 kHz (Auto)
- J-Link found 2 JTAG devices. Core ID: 0x3BA00477 (Cortex-M3)
- Connected successfully

[elesy_ural]

http://www.coocox.org/CoIDE/How_to_use_J-Link.html
Выбирай SWD

[inkHunter]

http://www.coocox.org/CoIDE/How_to_use_J-Link.html
Выбирай SWD

Reading symbols from c:\coide\workspace\1\debug\bin\1.elf...done.
file C:\\CoIDE\\workspace\\1\\Debug\\bin\\1.elf
target remote localhost:2331
0x00000000 in ?? ()
monitor interface SWD
monitor endian big
monitor speed auto
monitor flash device = STM32F105VC
monitor flash breakpoints = 1
monitor flash download = 1
monitor reset 0
monitor halt
load C:\\CoIDE\\workspace\\1\\Debug\\bin\\1.elf
Loading section .text, size 0x61c lma 0x8000000
Start address 0x8000000, load size 1564


и висит на 62 % ((((